XR 500 rear wheel bearings


2 replies to this topic
  • motonerd

Posted February 26, 2004 - 01:31 PM

#1

Hi everyone!
I'm wondering how hard it is to replace bearings and if there are any special tools required?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • BuddyK

Posted February 27, 2004 - 09:17 AM

#2

I have not worked on a 500 in quite a while (neat bikes)
but from memory you can drive them out from the opposite side pretty easy with a long punch.

  • XR250rdr

Posted February 27, 2004 - 09:44 AM

#3

If its the same as my 250 there is a holding screw on one side that needs a special wrench to get out.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.