2000Wr400 Shift lever assembly

No replies to this topic
  • HP224

Posted May 09, 2001 - 03:39 AM


Has anyone expeienced any problems w/the shift lever assesbly? On my bike the pin on the shift lever asm.thaqt th rollr sits on and the shift shaft goes over fell out during a ride. I disassembled the clutch and found the pin and the roller laying in the bottom of the case. I re-assembled and continued riding, however, it came apart again. I purchased a new asm. from the dealer, but I had the pin welded in this time, as opposed to the pressed fit from the factory. The dealer said this was a fluke, has anyone experienced this problem?


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.