2 base gaskets???


No replies to this topic
  • Hamish

Posted February 21, 2004 - 12:53 PM

#1

Last week I pulled my engine down for gearbox repais, and found that the previous owner had installed 2 base gaskets. The only reason for doing this that I can think of is that the head/barrel was decked and they needed extra piston/valve or piston/head clearance. I can't imagine why anyone would want less compression, unless they wanted to run low octane fuel. Knowing my luck if I refit 1 base gasket it'll end in disaster, so I'll do a piston/valve clearence checks first. If anyone has any ideas on why you would install 2 base gaskets please let me know :)
thanks
Hamish




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.