Handlebar Mount Stud

2 replies to this topic
  • tomerb

Posted June 14, 2015 - 07:02 PM


Will the stud in the stock bar mount that goes through the top triple clamp unscrew??

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • chu

Posted June 15, 2015 - 11:50 AM


I think it's a press fit into the lower clamp.

  • tomerb

Posted June 15, 2015 - 01:17 PM


Well I took the chance that they were threaded in with Loctite and put it in some soft jaws in the vice and put torch to stud till it started to smoke and with vice-grips I was able to remove it. It turned out to be a M12X1.25 thread and on that end and it's10mm on the other end. I got some 12mm bolts at ACE to replace the studs so now my spacers would fit under the factory bar mounts.


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.