Rear Suspension Maintenance questions



4 replies to this topic
  • DPW

Posted January 31, 2002 - 07:01 PM

#1

It's that time again to take apart the rear suspension and re-grease it. My question is what socket sizes are needed to take it apart and any special tools or make sure you have this xxxx before you start tips? The last time I torn it down was at a buddy's shop who had all the right tools, but this time I'm doing it at home and my tool collection isn't quite as good as his.


Thanks for your help

  • Scott_F

Posted February 01, 2002 - 08:14 AM

#2

You will need two 22mm sockets for the swingarm to linkage bolt, and a 22mm wrench for the linkage to frame bolt.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Scott_F

Posted February 01, 2002 - 08:16 AM

#3

Oh, and you might be able to use 7/8" if that is all you have.

  • yamaha.dude

Posted February 01, 2002 - 10:17 PM

#4

check out the thread on the WR250 side... grease fitting or something... it links to this old posting...

excellent instruction on what to do...

Have fun,

David

  • DPW

Posted February 02, 2002 - 04:21 AM

#5

Thanks for the info guys. I found the post yamaha.dude, thanks that's what I was looking for

If anyone else is interested here's the LINK

[ February 02, 2002: Message edited by: DPW ]





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.