3 replies to this topic
  • BK14MX

Posted January 24, 2002 - 05:38 PM


The hymec system I installed had been flawless, untill a week ago. It has sprung a leak at the slave cylinder, which caused air to get into the system. I had to come up with a way to bleed it, without Maguras little bleeder kit, which involved a few choice words, and lots of mineral oil, but I eventually got it figured out.

Is there a rebuild kit available for these things??? Anybody have a parts breakdown for them???? Its getting old having to refill and bleed it everytime before I go riding.

  • Ric_j_stallone

Posted January 24, 2002 - 11:00 PM


Does it leak from the threads where cap screws onto slave cylinder ? If so Magura knows about it and have made a new type of slave. They say I can have my replacement in a few weeks.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • BK14MX

Posted January 25, 2002 - 05:03 AM


Its actually leaking from the rod side. But if they are having problems with the model I have, it should be replaced then. The part is only about six months old. Did you deal with Magura directly, or your dealer???

  • Ric_j_stallone

Posted January 25, 2002 - 11:58 AM


BK14MX, I went to my dealer here in the UK they have been aware of this problem and pushed German company Magura to address it.Just a few tips on installing; I needed to file the cable holder and twist it a little so the slave cylinder could have free play when you pull it back and so the rod pulled "dead straight" My first one leaked as yours does and after fitting the second one as above, no problems.

[ January 26, 2002: Message edited by: Ric j stallone ]

Related Content


First Hare scramble tips by dhend8

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  33 replies

yz400f throttle bog by yz400fmaniac

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • * * * * *
  • Hot  28 replies

Michigan Motocross Tires by 288yz450

Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply

2016 YZ450 by CaptainKnobby

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.