3 replies to this topic
  • Dez113

Posted January 22, 2004 - 05:01 PM


I put an FMF Ti 4 exhaust with stainless powerbomb, and ti mid pipe on my WR450 and put in the 03-04 YZ450 power up jet kit from dynojet marketed by FMF. Don't do it it is totally wrong for the WR, which is my bad I just assumed it would be the same as most everything else has for a few years. Anyway I called them up and the have a WR450 in the shop on the Dyno this week and said they will have a power up kit for it sometime next week. Yea! :) I went back to stock jetting, 165 main, then dropped the clip to #5 and raised the pilot to the canadian #48, air screw 2 1/4 turns out. weather 55 degrees 2500 ft rain. it has no backfire popping, but cut a little around half throttle, and sputters a bit full throttle rpms about 80-90%. anyway stil fine tuning if anyone has the same setup and has some tips. Oh I also cut out the molded air holes on the right side of the airbox. (per last Dirt Rider Mag) :D

  • Indy_WR450

Posted January 22, 2004 - 07:04 PM


You got to get a JD jetting kit for your bike! Buy it from the TT store on this forum web site. Everybody is happy with the results on the WR450 with or without aftermarket pipes. :)

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • mtrablue

Posted January 22, 2004 - 07:14 PM


ditto on the j.d.

  • Eddie Sisneros

Posted January 22, 2004 - 07:19 PM


skip the dynojet kit.go with the JD kit.dynojet likes to use F taper much taper for the big bike.


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.