Low vs high for handle bars for mx

No replies to this topic
  • Mtrain730

Posted June 08, 2014 - 05:55 AM


Hey guys I'm running the pro taper windham Bend on 2012 yz450 I like them they did make it so I can slide farther up on the bike and they do feel great when standing the only down side I could see and tell me if my logic is wrong is that when really trying to corner hard is having a higher bar Bend hurting me. I know people's opinion go back and fourth on this and at the end of the day just do what makes you comfortable but I was thinking that you might get a better attack position heading into the corner being able to really lean over the front of the bars while seated instead of having your hands and arms more out in front of you. I know every thing is compromise but am I correct. I would think if there lower they would allow it to be easier for you to push down entering the corner. Hope this post makes sense. By the way I'm about five foot ten and I have the windhams rolled back slightly.

Edited by Mtrain730, June 08, 2014 - 06:04 AM.

Related Content

WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

James Stewart back on a YZ450F by YamaLink

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies

Wilson the Blue Privateer by jetfuel

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  50 replies

Should I buy this bike? help....... by Numsa Hul

Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies

1998 yz400f will not idle. by trolley

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  32 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.