I need your opinion - YZ time



3 replies to this topic
  • guillev

Posted May 01, 2001 - 11:02 AM

#1

Hello, i need your opinion about yz time in my wr 400 '00
Why I must to setup my bike with that time?
gUiLLe

  • MN_Kevin

Posted May 01, 2001 - 01:49 PM

#2

You gain in the midrange and top end and may lose a little off the bottom.

You don't have to do anything you don't want to. :)

------------------
'99 WZ with all YZ mods, de-octopused, FMF PowerBomb header, Stroker SX-1 silencer, SS front brake line, forked over by Pro-Action, OEM YZ tank, IMS YZ seat, carb mods by Jim Dean and Sir "Taffy" from Jolly Old England, AMA, NESC.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Blue_Boner

Posted May 01, 2001 - 05:24 PM

#3

If you want your bike to have instant front wheel pulling power then switch to YZ timing. I have made the switch on my 400 and love the fact that I can lift the tire anytime needed. It may hurt bottom end power a little, but this engine was designed to run in the upper rev's anyway.

------------------
98 WR400 "Strokerized"
97 EXC400
94 RMX250

  • robin_des_bois

Posted May 02, 2001 - 04:22 AM

#4

I changed the timing on my wr99 road plated and didn't see a realy noticeable difference in loosing bottom torque. However, mid where improved. Go for it, the hardest thing is not the timing change but the rejetting. It will cost you a couple of hour in time and may be a main jet and a needle, no more.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.