426 Complet Clutch on 400


6 replies to this topic
  • mikseven

Posted February 26, 2014 - 05:29 AM

#1

Hi all,

I'm considering to buy a complete WR426 Clutch (Basket, Center Hub, Pressure Plate, Spring, Push rods, actuator and plates).

 

Is it installable on a WR400?

 

I need to replace my Clutch due to eccessive wear and with the 426 it will be possible to mount the newest Rekluse Products.

 

Thank

Mik



  • mikseven

Posted March 02, 2014 - 12:46 AM

#2

Nobody can help me?


Mik

  • rosedog

Posted July 11, 2014 - 07:08 AM

#3

Hi mate. Did you end up doing this? I was searching fir an answer for the same question so i can fit a rekluse to my 400.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • mikseven

Posted July 11, 2014 - 07:34 AM

#4

Hi mate. Did you end up doing this? I was searching fir an answer for the same question so i can fit a rekluse to my 400.

Hi Rosedog, 

yes, it works.

 

You need to replace entire Clutch with the 426 model. Actuator, primary drive, hub, Friction/Drive Plates, pressure plate and springs.

If you need to install a Rekluse, only actuator, primary drive, Drive/Friction Plates are needed. Pressure plate and spring are not used.

 

If you find a Z-start pro is good enough. A core Exp is better.



  • rosedog

Posted July 11, 2014 - 08:57 AM

#5

Cheers mate. I brought a 2002 wr400 as a parts bike has a seized engine. Was just looking to see if the clutch was the same as 2002 426, but i think it is different. As far as i can tell it has 1 less plate and 1 less spring. So will continue to search i think. Thanks for your help.

Edited by rosedog, July 11, 2014 - 08:59 AM.


  • mikseven

Posted July 11, 2014 - 12:57 PM

#6

Cheers mate. I brought a 2002 wr400 as a parts bike has a seized engine. Was just looking to see if the clutch was the same as 2002 426, but i think it is different. As far as i can tell it has 1 less plate and 1 less spring. So will continue to search i think. Thanks for your help.

Yes The 400 has a clutch with 5 Springs directly derived from xt & tt series. The parts are completely swappable. If you are lucky you can find a Rekluse z.Start, the 1st version. It works great. I ran some Italian Rally Championship Races without problems.

 

The only advantages of the 426 clutch is that you can use more recent Rekluse Systems.



  • rosedog

Posted July 11, 2014 - 11:48 PM

#7

Thanks mate. It seems a bit hard to find info on these bikes now, and alot of blokes font want to share their knowledge. Your a legend




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.