2006 YZ450 full oil capacity?

12 replies to this topic
  • 700rScott

Posted February 15, 2014 - 03:09 PM


I replaced my stator with an HD stator and I'm wondering how much oil dose it take? I've added 2qts so far and there's nothing on the dip stick.

  • nardski659

Posted February 15, 2014 - 03:30 PM


I believe it's 1 qt

  • trandyd

Posted February 15, 2014 - 03:38 PM


Hold's 1.27 quarts with filter change, 1 quart without filter change.  It will not show up on the stick until you crank it.  2 quarts is way to much. 

  • 700rScott

Posted February 15, 2014 - 04:40 PM


Ok, I thought it was around that but didn't realize I have to crank it for it to show up on the stick. Thanks.

  • grayracer513

Posted February 15, 2014 - 07:59 PM


Read: http://www.thumperta...9-model-yz450s/

  • 700rScott

Posted February 16, 2014 - 05:35 PM


Thanks Gray. Do you have any options for getting the other qt out?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • 700rScott

Posted March 10, 2014 - 09:45 AM


I tried to get the other qt out but I was only able to get a 1/4 qt out. What is the amount of oil the bike takes when you do the bottom end or replace the stator?

  • grayracer513

Posted March 10, 2014 - 09:58 AM


If you completely disassemble the engine and are filling it for the first time after that, it takes 1.2L (1.27 qt)


Otherwise, it's the same thing; 1 qt without a filter replacement, 1 Liter with a filter.

  • 700rScott

Posted March 10, 2014 - 12:24 PM


Ok cause I had the fill cap and dip stick hole open and I wasn't getting anymore than a 1/4 after putting in 2qts in.

  • grayracer513

Posted March 10, 2014 - 12:30 PM


If you don't run the engine after filling the oil, nothing will show on the dip stick because you fill the oil into a different volume than that where the stick is located.  The way it works is, drain, fill, run, check, in that order.  Otherwise, the oil will just stay in the sump instead of being pumped out and into the oil reservoir where the stick is. 

  • 700rScott

Posted March 10, 2014 - 12:46 PM


Ok thanks what I was thinking. I didn't start it up but I did kick it over a few times to try to get it moving around.

  • grayracer513

Posted March 10, 2014 - 01:18 PM


It needs to run for 30-45 seconds at least.

  • 700rScott

Posted March 10, 2014 - 01:51 PM


Thanks and I knew it was in there but wasn't sure where it went.

Related Content

WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

Help with 2000 yz426 by weekend woods racer

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  36 replies

YZ450F 03 Sparks driving me crazy by SirAttard

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies

Chubby dad, looking at bikes , First trip to the orange/black forum ! by Slow_ride

Dirt Bike   Make / Model Specific   KTM   250-530 EXC/MXC/SXC/XC-W/XCR-W (4-Strokes)
  • Hot  28 replies

Is the 2016 GYTR Yamaha YZ450F too fast? by Fryboy

Dirt Bike   Special Interest Forums   Pro Racing
  • * - - - -
  • Hot  241 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.