Jump to content

WR450 dead battery


Recommended Posts

Hi everyone,

 

I must have forgotten to switch off the ignition last time (one week ago) I rode the bike and the battery went dead since the lights stayed on probably.

I had to kick start the bike to run it but after five minutes I switched it off, but still not enough charge to start the bike with electric start.

 

My bike is a 2013 WR450, it has only 500 miles and the battery never went dead before (always started great first time with electric start).

 

Do you think I need to ride it for a while for it to charge properly?

Do you think the battery is completely dead as in, will I need a new one?

 

 

Thanks

 

Link to comment
Share on other sites

It will need to be run for more than 5 min to charge the battery, that's for sure, or hook it up to a battery charger.

 

Completely draining a battery isn't good for it, but I drained the stock battery on my 2006 WR450 a dozen or more times over the course of 5+ years before it eventually bit the dust so yours should come back after it gets a full charge.

Edited by woods-rider
Link to comment
Share on other sites

When the bike is idling, it isn't producing enough electricity to run the bike and charge the battery at the same time.  

Once the engine is at a higher RPM, it turns faster and produces more electricity, thus charging the battery more effectively. 

 

Right, but RPM has little to do with speed.

Link to comment
Share on other sites

Could I bounce it off the rev limiter in neutral for 10 minutes or so if I don't feel like going 20+ mph?

 

Yeah, if you don't mind boiling over and floating a valve.....

 

Hence, the minimum of 20 mph, a approx speed number to reach the minimum speed required to both charge the battery and not overheat. 

Link to comment
Share on other sites

While troubleshooting my dead regulator/rectifier I was checking the stator to see if it was putting out voltage. At idle I was getting 35 volts ac. At ~5000 rpm it was putting out 79 volts ac. Manual says the regulator/rectifier should put out 14.0 volts dc. I am not an electrical engineer so I have no idea how many volts ac it takes to produce an output from the recg/rect of 14.0 volts dc.

Link to comment
Share on other sites

  • 2 weeks later...

Hello gents,

 

Just to update, I had to remove the battery from the bike and use a batt charger to charge it properly. Now it is working fine again.

 

I tried to ride the bike for more than 25 minutes and still when I got back home, tried to start it with electric start but no luck.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

×
×
  • Create New...