Jet kit and Fuel Screw ordered today



4 replies to this topic
  • sjwr450

Posted January 07, 2004 - 07:39 AM

#1

I ordered the JD jet kit and Zip-Ty fuel screw today. Any advice for install?

  • Indy_WR450

Posted January 07, 2004 - 08:00 PM

#2

Start with 165 main, Red needle clip #5 and zip ty at 1.5 turns for 50 - 60 degree weather at 250 feet elevation. :)

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • WR450F_RDR

Posted January 08, 2004 - 05:38 PM

#3

see my signature line, I love difference with the JD needle kit.

  • GrahamO

Posted January 08, 2004 - 05:50 PM

#4

Hold on.

I was disappointed at first, couldn't notice a difference. Then I came around a corner in third, hit the gas and the front end came up like it never had before.

Unless you have a dyno, you might not feel anything at all.

  • Anthem

Posted January 13, 2004 - 05:56 PM

#5

I saw the diff instantly, but my jetting may have been off pretty darn far before the JD. I'm getting through revs a lot quicker, and I snapped my back fender off on my first wheelie try after the install. The directions that come with it were perfect.

The screw also has good instructions, just be careful taking out the old one. I thought I had lost the washer and o-ring but it turned out they were still in the hole. It's spiffy.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.