FCR zip-tie mod/accel pump problem?

No replies to this topic
  • Twin-350

Posted November 09, 2013 - 08:07 AM


So I was jetting my 06 yfz450 yesterday and decided to do the zip Ty mod despite the fact that the pump was timined fine and had 0 lag I wanted to make sure it stays like that. Well my question comes from the fact that I went and looked at the pump on my 04 yz450f and it seems to lag A LOT. It responds instantly but when i WOT quickly it falls behind. It sounds like I can hear the plunger too. Like it's moving along an old piece of rubber. I've never had a problem with it bogging as 1/2 throttle is all I ever really need but I did the zip ty mod to it and it sped it up a lot but towards the end of the stroke it seems to slow down. Is this a worn out part? Is it just less timing on the bike? I think I could get by without it really but at the track I don't want it to bog on the face of a fat jump. So is it stock timing or should I replace some stuff down there?

Related Content


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.