squeek in my wheels

1 reply to this topic
  • roostin426

Posted December 19, 2001 - 11:20 AM


hey how easy is it to grease the bearings? or do i even need to. any advise is helpful

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Guest_Guest_*

Posted December 19, 2001 - 04:38 PM


I just did mine again the other night. Very easy.
My front wheel would drag horribly when spun on a stand. the back too but kinda' expected because of the chain. I pulled them off and pulled the caps and pulled the seals / cleaned up as much crappy lookin' stuff as I could. Then I simply used my fingers to PACK grease back into them.
Shove the seals and caps back and WALLA'
As soon as that was done I spun the wheels and both were at least 2 to 3 times better!
No more drag. :D

Related Content


Michigan Motocross Tires by 288yz450

Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply

yz400f throttle bog by yz400fmaniac

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • * * * * *
  • Hot  28 replies

Help with 2000 yz426 by weekend woods racer

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  36 replies

Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies

100 hrs on 2014 yz450f, shim valves or replace them? by ttr230rider6

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  79 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.