Replacing Fork Seals in an 05 WR450F


No replies to this topic
  • Fruitfarmer231

Posted October 02, 2013 - 07:06 AM

#1

Tried replacing seals a bit back and they are leaking,  so going back after it.   But question is are these 45mm or 46mm tubes?   Most of the seal drivers I've seen advertised go up to 45mm  and some 47mm.   The driver I used last time was a piece of 2" PVC split in half,  appeared to me that I needed to bevel the PVC so that it didn't contact the inner edge of the seal,  only the outer.    Thought I had been successful,  but evidently not.  

 

 






 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.