how do remove of clutch push lever 09 yz 450f



2 replies to this topic
  • mxpx21

Posted September 11, 2013 - 07:59 PM

#1

I need to remove my clutch push lever on my 09 yz 450f because oil is leaking out of the o-ring and I have no idea how it comes off.  Can I pull it off with my case still on the bike?  If there is a easy way to pull this do it with my case still on the bike can someone let me know? 



Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted September 12, 2013 - 07:12 AM

#2

The release arm is retained by the clutch push rod that runs through the main shaft.  To remove the clutch release arm, you have to expose the clutch and remove the pressure plate.  Then remove the outer clutch push rod and the steel ball behind it.  At that point, you can draw the inner push rod out a half inch or so, which will allow you to lift out the release arm. 



  • mxpx21

Posted September 13, 2013 - 12:46 PM

#3

ok that sounds easy enough to do.   Do i need to replace he bearing on the clutch push lever when I replace it the rubber oring and clip?







Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.