Stumped by 2004 YZ450F

No replies to this topic
  • rcv450f

Posted July 24, 2013 - 06:09 PM


I need help with this pain in the ass bike that will not produce a spark. Below is the list of parts that have been replaced.

a) Stator - ohm values check with book
c) Ignition coil

Kill switch and neutral switch work, new wiring harness, and good ground connection.

The CDI is a used unit but before I order a new one I want to make sure the stator is working properly. Like I said ohm readings on stator are per the book and would ilke to test voltages coming out of the coils on the stator. Any ideas of what voltage ranges I should be getting on the 2004 model? A fluke meter with peak reading capabilities will be used. Since these are peak readings I assume VDC should work fine or should I set the meter to VAC?

Related Content


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.