Panoram magnet Idea, 01 WR426



No replies to this topic
  • Derek_Burns

Posted April 26, 2001 - 12:04 PM

#1

If you have a problem with your magnet falling off, you may like to try this.

The button magnet supplied by Trail Tech fits neatly into the donut rivets on the floating disk (rotor), but only fits in one side. If you place it inside and put a thin 6mm st/st washer over it, tig weld the washer on with a few tiny stitches, it works fine, and definately wont fall off.

Del




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.