2010 Front Brake Push Rod Length

3 replies to this topic
  • kjh440

Posted May 17, 2013 - 11:40 AM


I have just recovered my bike that was stolen in Jan and putting back together. All looks fine but the front brake. Received the bike without a front brake lever or bolt. Have tried to install a new handle and don't recall this much issue before. Seems like I can't get the push rod installed far enough in to get the bolt started. Not sure if it is the correct length. Does someone have this length?

  • grayracer513

Posted May 17, 2013 - 01:22 PM


If you are using a lever made for an '07 or earlier model, it won't work. You'll have to get one for an '08 and up.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • kjh440

Posted May 17, 2013 - 02:14 PM


This push rod was with the bike when returned. I am looking to verify if this is the right one.
Do you know where I can find this measurement?


  • grayracer513

Posted May 17, 2013 - 07:10 PM


You'll probably have to find one on another bike and measure it.

Related Content


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.