Cylinder height

No replies to this topic
  • mxrider_414

Posted April 24, 2013 - 03:31 PM


I am doing a top end, cam chain, ect on my 2010 YZ450f that I bought used last year and they head has the signature of an engine builder on the side. I know it has been ported but I am planning on using a high compression piston and want to make sure the cylinder wasn't machined for higher compression already. Does anyone know the height of the cylinder from gasket surface to gasket surface? If not could someone put some calipers to theirs on the outside and check?


Related Content


Megabomb Fitment by 288yz450

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 1 reply

The "going back to the other darkside" adventure... by Monk

Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies

Should I buy this bike? help....... by Numsa Hul

Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies

Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies

James Stewart back on a YZ450F by YamaLink

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.