How to break in a cr500?


1 reply to this topic
  • 96cr500

Posted April 16, 2013 - 09:10 AM

#1

I have just rebuilt a 96 cr500 from the ground up nothing is untouched in the engine (wiseco piston, pro x rod, all balls bottom end bearings, new water pump, new jug) What do i need to do to break it in right so it will not have any problems in the future?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • DrFeelGood

Posted April 16, 2013 - 09:27 AM

#2

http://www.sacoriver...ed/breakin.html

:excuseme:





Related Content

Forums
Photo

2006 cr 85 running bad/ sputtering by Honda2smokerider23


Dirt Bike   Dirt Bike Technical Forums   Intake - Jetting / Fuel Injection
  • 0 replies
Forums
Photo

2006 CR125 Rattling (Piston Slap?) by Will I Am


Dirt Bike   Make / Model Specific   Honda   Honda 2-Stroke
  • 23 replies
Forums
Photo

2003 CR250 by asealy20


Dirt Bike   Make / Model Specific   Honda   Honda 2-Stroke
  • Hot  34 replies
Forums
Photo

Largest Dirtbike engine sizes by sroemer_426


Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  57 replies
Forums
Photo

Starting CR 125 after sitting for a couple of years by savagenix


Dirt Bike   Make / Model Specific   Honda   Honda 2-Stroke
  • 12 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.