I have a Yamazuki where do I fit ?


1 reply to this topic
  • xxcody2gunsxx

Posted March 16, 2013 - 09:21 PM

#1

I have a 2012 Suzuki drz400s with 2008 Yamaha YZ450 Forks and triple clamps .
I am having a little bit of binding when turning it to the right side . wonder if its the races or not .
the races are from the original DRZ400S . the 2008 dont seem to fit .
also wondering what the torque is for the stem nut . maybe I have that too tight .
I also have a 39mm FCR 39mm MX carb from the 2008 YZ and I want to install . any help there?

Posted Image
Posted Image

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted March 17, 2013 - 08:28 PM

#2

The YZ stem sets up this way:
  • With the bearings cleaned and lubed, run the ring nut down to around 25 ft/lb and rotate the bottom clamp side to side a few times.
  • Loosen the ring nut about a full turn, then retighten to 6-7 ft/lb
  • Install the top clamp and tighten the crown nut to 105 ft/lb
What I don't know is whether the dimensions of the DRZ races match up with the YZ bearing assemblies well enough to work right or not.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.