Port and Polish



1 reply to this topic
  • Bob_Collier

Posted November 13, 2001 - 04:23 AM

#1

I have 1999 yz400. Thinking about port and polish job. I know some of you have had this done. I am concerned how much carb problems people had after job was done. Any adice.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • yzf

Posted November 13, 2001 - 08:33 AM

#2

i had a 1999 yz 400 with a 426 big bore kit and ported and polished head all i had to do is go up two sizes and the main and one size on the pilot and down one clip position on the needle ,bike ran great no bog ether MUCH more bottom end a little more on top too





Related Content

Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

BIGBORE FOR YZ450F 2006? by Taattie94


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
Forums
Photo

YZ450FX OR YZ450F by MESSMAKER


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  30 replies
Forums
Photo

Chubby dad, looking at bikes , First trip to the orange/black forum ! by Slow_ride


Dirt Bike   Make / Model Specific   KTM   250-530 EXC/MXC/SXC/XC-W/XCR-W (4-Strokes)
  • Hot  28 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.